GE Healthcare · X-ray R&F2226456
Connectors on RAD I/F board changed
Symptom
Connectors on RAD I/F board changed Replacement of the Jedi RAD I/F Board 2226456-4 may present some connection compatibility issues on installed base Proteus XR/a Systems. The type of connector used on the board for the J5 and J6 Bucky connections and the J7 Room Door and Warning Light connections was changed. See attached picture – the white connector was the original type used; the orange connectors are the new type used. The two types are not compatible and are not interchangeable.
Applies to
- Product
- PROTEUS XRa
- Component
- RAD I/F Board 2226456-4 RAD I/F Board 2226456-4
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug