GE Healthcare · X-ray R&FRevolutionPrecisionOptimaDiscovery
Collimator copper filter is broken
Symptom
Collimator copper filter is broken During system boot, collimator drives copper filters to and from position, checking movements. This failure is both seen by a failure to drive and by a failure of the collimator to complete BIST. System will be inoperable due to collimator failure.
Error message
Collimator failure
Applies to
- Models
- Revolution, Precision, Optima, Discovery, Definium
- Product
- Revolution XRd2X Precision 500D Optima XR640 Discovery XR650 Definium 8000 Revolution XRd Gipeto Version PROTEUS XRa Revolution XRd
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.