GE Healthcare · X-ray R&FDefinium
Daylight Savings Time on the Gipeto (XRd)
Symptom
Daylight Savings Time on the Gipeto (XRd) If the system was configured for a specific Time Zone during the initial configuration of the Unix load, then when DST comes into effect at the software routine time, then the clock will change. Since the new DST is 3 weeks earlier this year, we updated all systems manually. Now the DST regular software routine came around, it changed automatically again. Time of system clock changes on all Time Stamped images and logs, and they are now 1 hour off the correct time.
Applies to
- Models
- Definium
- Product
- Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.