GE Healthcare · X-ray R&FDefinium500211
Error 50-0204 Filament permanent open circuit
Symptom
It can't exposure when use small focus,but large focus exposure was normal.
Error 50-0204 Filament permanent open circuit Intermittent Error Code 50-0204 (Filament permanent open circuit).
Error message
50-0204 Jedi error code See long description for details Filament permanent open circuit - Issued by the Heater board when an open has been detected and 3 restarts have been tried without success within 100 ms. Potential causes: 1. X-ray tube filament open 2. Heater to HV Tank cable 3. Cathode HV cable or pin contacts 4. Open circuit in filament transformer inside HV tank. 50-0211 500211 Jedi Error Code
Applies to
- Models
- Definium
- Product
- Definium 8000
- Software
- All Versions
- Component
- x-ray tube(MX100,part#: 46-233946G8) x-ray tube(MX100,part#: 46-233946G8) Xray Tube
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.