GE Healthcare · MR224881622488152248814
CWA Auto Prescan Failure Due to metal present in anatomy, bandages, braces, dental work, etc.
Symptom
Unable to scan with Power Monitor Faults
Error message
2248816 RF Interface (RFI) High Voltage Relay Fault 2248816, RF Interface (RFI) High Voltage Relay Fault. Possible causes: RF Monitor Cable to System Support Module (SSM) is disconnected or defective. 2248815 Power Monitor 2 Fault. RF Transmit power has reached safety limit allowed for scan parameters and patient weight. Check patient weight entered. This could also occur when power cycling SSM. 2248814 Power Monitor 1 Fault. RF Transmit power has reached safety limit allowed for scan parameters and patient weight. Check patient weight entered. This could also occur when power cycling SSM.
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR4-HFO4 Software version for HFO4 system, which is OpenSpeed with Excite Technology
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Will Not Scan With RF Errors Due To SSM.
- Auto Prescan Fails.
- CWA ID135438.Unable to scan with power monitor faults due to the two halves of the knee coil not being connected.
- Unable to scan with RF errors due to RFI.
- Power monitor fault due to SSM.Unable to scan with Power Monitor Faults.SecondOpinion System Support Module 2160200-43 wqr.Excite.2248814 Power Monitor 1 Fault.11.1
- RF calibration not in specification.