GE Healthcare · Nuclear Medicine
VG system start up getting error #152, DRIVER ENABLE failure, Axis=$
Symptom
VG system start up getting error #152, DRIVER ENABLE failure, Axis=$
Error message
Error # 152 (Error 152) Test: DRIVER ENABLE failure, axis=$ GANTRY_ERROR_TST_DRV_FAIL
Applies to
- Product
- VGH VG and VG Hawkey and Varicam
- Component
- DTP000150 VG Drivers Block Assembly (ELMO Motion Control) Aerotech Upgrade DTP000150 VG Drivers Block Assembly (ELMO Motion Control) Aerotech Upgrade The VG Aerotech Driver B010216022 has been replaced by ELMO Motion Control DTP000150 due to unavailability of the old driver. Service Note 43247 The following parts are included in DTP000150 and can be ordered separately as required ELGEMS Part Number Description Axis Qty B010200223 Drivers: ELG-200 Radial 1 & 2 and Up/Down Table 1 B010200222 Drivers: ELG-55 Swivel & Backward/Forward Table 1 PS000401212 LAMBDA LWD15-1212 Dual Power Supply 1 *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop