OTS drops vertically when using Auto Position
Symptom
OTS drops vertically when using Auto Position See long description. When driving OTS using Auto Positioning, OTS will begin to drive down prior to reaching destination. This usually occurs when driving to Table, but can occur when driving to WS. This tends to occur when driving the OTS using Auto Position from either Park or WS to Table. The OTS will drive up to the calibrated position as normal and will begin to move toward the selected destination. Once the OTS gets close to the final destination, the OTS appears to drop downward. This movement could strike the patient. If this occurs, create and submit an safety report.
OTS drops vertically dirver error
Error message
1090419 - OTS Vertical Amp is not alive
Applies to
- Models
- Definium
- Product
- Definium 8000
- Software
- All Versions
- Component
- Wallstand (Thunder)
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.