Service Note 43868_1 Aug/10 DS7/X NewLine, DST/DSTXL with FEA electronics and iSeries Cameras - LED Pulse in Hardware Of…
Service Note 43868_1 Aug/10 DS7/X NewLine, DST/DSTXL with FEA electronics and iSeries Cameras - LED Pulse in Hardware Offsets
Symptom
Service Note 43868_1 Aug/10 DS7/X NewLine, DST/DSTXL with FEA electronics and iSeries Cameras - LED Pulse in Hardware Offsets Service Note 43868 _1 Aug/10 DS7/X NewLine, DST/DSTXL with FEA electronics and iSeries Cameras - LED Pulse in Hardware Offsets The LED Pulse can cause false peaks in Hardware Offset Calibrations, LED Testing or in the Spectrum if the CAN setting for W channel (energy) is too high. This document explains how to adjust the CAN to eliminate the false peak.
Applies to
- Product
- SMV DS Camera SMV DS Camera SMV DS Camera
- Component
- *Detector (Imaging Detector) *Detector (Imaging Detector) *Detector (Imaging Detector)
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop