GE Healthcare · X-ray R&F
Plalpator assembly intermittent cannot move.
Symptom
Plalpator assembly intermittent cannot move. Plalpator assembly intermittent cannot move.Try reboot system the Plalpator assembly can work normally a while, but just wait 5 to 10 minutes or try up and down the assembly sometimes, the assembly cannot move else.
Applies to
- Product
- Prestige SI
- Component
- replace 2A1 CIRCUIT OF RELAYS BOARD replace 2A1 CIRCUIT OF RELAYS BOARD parts number:2169234
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug