GE Healthcare · X-ray R&F
XRd2X IDC communication failure in the error log.
Symptom
XRd2X IDC communication failure in the error log. This failure happened AFTER the exposure was triggered. While troubleshooting, checked wire connections at rear of the ADS computer. When touching one of the IDC Cat6 cables, the Console beeped.
Error message
"System Communication Error" on Advantx Console
Applies to
- Component
- FCIB in IDC same as the FCIB in RATC of INNOVA
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug