GE Healthcare · MRSigna2247378104577
Zipper Artifacts in Shoulder Images and UTNS Notch Diagnostic Fails with Error Code 2247378 due to Uncovered Holes in Pe…
Zipper Artifacts in Shoulder Images and UTNS Notch Diagnostic Fails with Error Code 2247378 due to Uncovered Holes in Penetration Panel.
Symptom
MRIQ Zipper Artifacts in Shoulder Images and UTNS Notch Diagnostic Fails with Error Code 2247378 See Long Description The noise spike counters in the RRF chassis incremented during UTNS diagnostics when the UTNS was not injecting large test spikes.
Error message
2247378 The noise spike counters in the RRF chassis incremented during UTNS diagnostics when the UTNS was not injecting large test spikes. The UTNS or DIF boards might be notching the RF signal unnecessarily. See Long Description for the complete error message Error: 2247378 Host: signa3 Process: diagCoord File: rrfUtns3.c Line: 406 Diagnostic: UTNS Notch Iteration: 1 of 1 Action: 1 Task ID: 0x7f541f0 Time: 104577 Object: APS Test Task Function: Software/Firmware/Config: N/A The noise spike counters in the RRF chassis incremented during UTNS diagnostics when the UTNS was not injecting large test spikes. The UTNS or DIF boards might be notching the RF signal unnecessarily. 487 spikes detected on RF channel 1, expected 0.-> Extended Error: The UTNS can chop out a noise spike on the receiver channels when it sees a spike larger than some preset level. This UTNS detected spikes when it should not have seen any spikes. The board could be faulty or perhaps something is injecting noise into the system. Verify that the room door is closed or disconnect the UTNS antennas from the UTNS boards while running this test.
Applies to
- Models
- Signa
- Product
- Signa HDxT This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software. This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software.
- Software
- 15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.