PROTEUS What needs to be done when the KV Control Board in a Proteus JEDI Generator is replaced?
Symptom
PROTEUS What needs to be done when the KV Control Board in a Proteus JEDI Generator is replaced? The replacement board CANNOT be used as received. It comes loaded with V5.47 software for the CT version JEDI Generator. The JEDI will run with this version of software, but strange things will happen, like transposition of values in the kV, mAs, etc. boxes on the Proteus console screen. There is also a floppy disk that comes with the replacement kV Control Board. This floppy disk is NOT to be used. It contains V4.25 software used with the Silhouette VR version JEDI Generator.
Applies to
- Product
- PROTEUS XRa
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug