GE Healthcare · MRSigna2252112

Application software will not boot Due to SCP or SCP2 Board.

Symptom

HP Computer Will Not Boot Applications Software

Error message

2252112 Board SCP is in invalid power up state 2 See Long Description Verify ENV parameters and retry power up. Extended Error: The board may be in one of the following states: 0 - No response, 1 - OS Loaded, 2 - PPC Bug, 3 - PPC Diag, 4 - OS not loaded If the error message states that the board is in state 4, then the OS load was stopped. This may happen if characters are detected on the serial cable. In order to eliminate this problem, disconnect the serial cable from AGP/COM1 Connector or SCP/Console Connector and reboot the board. If the error message states that the board is in state 2 or 3, then run the Motorola Board Level Diagnostics to verify the board is OK. If the BLD passes but this message appears during TPS reset then it is highly probable that the boards are not being reset by STIF connection. You can verify if the boards are not being reset by STIF connection during TPS reset either by looking at the LEDs on front of the boards or by opening MGD Terminal window.

Applies to

Models
Signa
Product
Signa HDxT This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software. This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software.
Software
15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
Component
2294300-19 MGD SCPII with CAN PMC and I2C firmware fix 2294300–19 SCP2 BOARD
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues