Detector housing and XRT housing cooling fans are inoperative
Symptom
Detector housing and XRT housing cooling fans are inoperative See Long Description The D5K Detector housing and the XRT housing cooling fans are inop, no +24vdc power at the Detector housing rear cover area J12 (connector pins 1 & 3, ref to pins 2 & 4). The +24vdc at TS4.9 or TS4.10 reference to Gnd Pwr at TS4.11 or TS4.12 terminals = ~5vdc. The XRT housing cooling fan power connector TS10 also does not have +24vdc present. The TS10 terminal strip is behind the XRT rear housing cover plate, mounted under a small cover, between the XRT Anode and Cathode. The TS10 +24vdc at TS10.9 or TS10.10 reference to Gnd Pwr at TS10.11 or TS10.12 terminals also = ~5vdc.
Applies to
- Models
- Definium
- Product
- Definium 5000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.