GE Healthcare · X-ray R&FDefinium
Auto Position protocols error with "Out of Tolerance, Calibration required" messages
Symptom
Auto Position protocols error with "Out of Tolerance, Calibration required" messages See Long Description The D5K positioner gantry was recently serviced, and now some of the application's Auto Position protocols error with "Out of Tolerance, Calibration required" messages.
Error message
Out of Tolerance, Calibration required
Applies to
- Models
- Definium
- Product
- Definium 5000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.