Issues completing the Generator Digital mA Loop Closed Calibrations
Symptom
Issues completing the Generator Digital mA Loop Closed Calibrations See Long Description The D5K Generator HT Controller Board and/or the HV Transformer were replaced and the service team needs to perform the Generator Digital mA Loop Closed calibrations. The calibration procedure is confusing. The service team cannot seem to complete the calibration sequence properly. Capturing the required mAs on the meter has been a challenge while trying to complete the E03 & E05 calibration sequences. The resulting extended memory numbers for E03 & E05 are now at 180, which is below the expected range. Initially both of these values were above 200.
Applies to
- Models
- Definium
- Product
- Definium 5000
- Component
- HT Controller Board
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.