Pre-alarm light is caused by the coolant level reaching the upper Low limit.
Symptom
Fault light is on the MEDICOOL/HX 10.0 P7 Gradient water heat exchanger Control Panel Power Switch: Power ON / OFF Power Indicator: Light when power on Running Indicator: Light when operate normally Alarm Indicator: Light when reservoir level reaches low alarm line Pre-alarm Indicator: Light when reservoir level reaches high alarm line Reset: Push to reset Alarm Indicator Stop/Start: To start/stop running Control Panel Power Switch: Power ON / OFF. Power Indicator: Light when power on. Running Indicator: Light when operate normally. Alarm Indicator: Light when reservoir level reaches low alarm line. Pre-alarm Indicator: Light when reservoir level reaches high alarm line. Reset: Push to reset Alarm Indicator. Stop/Start: To start/stop running. Medicool/HX 10.0 P7 Users Manual
Error message
Gradient water heat exchanger Pre-alarm Indicator Light when reservoir level reaches high alarm line Pre-alarm Indicator Light when reservoir level reaches high alarm line.
Applies to
- Models
- Signa
- Product
- Signa HDxT This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software. This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software.
- Software
- 15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
- Component
- 2297672 50/50 PROPLYENE GLYCOL MIX GE number 2297672 is premixed with Distilled Water and YELLOW in color. GLYCOL, 1 GALLON/3.8 LITERS. Coolant is the same GE part number in both Ellis and Watts and Medicool chillers and is a mixture of propylene glycol and purified water (50/50 mixture) GE number 2297672 is premixed with Distilled Water and YELLOW in color. GLYCOL, 1 GALLON/3.8 LITERS. Coolant is the same GE part number in both Ellis and Watts and Medicool chillers and is a mixture of propylene glycol and purified water (50/50 mixture)
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.