GE Healthcare · Nuclear MedicineMillennium
Millennium 3 Axis Table lateral axis can be manually pushed
Symptom
Millennium 3 Axis Table lateral axis can be manually pushed
Applies to
- Models
- Millennium
- Product
- MPR/MPS Millennium MPR Millennium MPS MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Software
- Genieacq All Genieacq All Genieacq All
- Component
- 5220379 Genieacq SW R4.5 V014 M4 with accumulative patches 5220379 Genieacq SW R4.5 V014 M4 with accumulative patches GA450-05-1, GA450-6-1, GA450-07-0, GA450-08-1, and GA450-09-0 Also 5237327 Genieacq software R4.5 build 14, FMI 40813 *Patient Table *Patient Table *Patient Table *Software Software Software
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size