definium 8000 - Cu (copper) filter selection does not change when switching protocols, the filter selection di…
definium 8000 - Cu (copper) filter selection does not change when switching protocols, the filter selection displayed in screen is correct but filter is not set accordingly at the collimator.
Symptom
definium 8000 - Cu (copper) filter selection does not change when switching protocols, the filter selection displayed in screen is correct but filter is not set accordingly at the collimator. Filter change can be forced by manual selection at the applicat definium 8000 - Cu (copper) filter selection does not change when switching protocols, the filter selection displayed in screen is correct but filter is not set accordingly at the collimator. Filter change can be forced by manual selection at the application screen or directly at the collimator.
Applies to
- Models
- Definium
- Product
- Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.