How to run DC Offsets or Other Calibrations Outside of Installation Calibration Wizard ICW.
Symptom
How to run DC Offsets or Other Calibrations Outside of Installation Calibration Wizard ICW See long description FE wanted to run DC Offsets are required by the Grafidy3 procedure, but when he hit the Calibration tab in the service browser, only the Installation Calibration Wizard (ICW) appears there. When he selects DC Offsets inside of ICW there is a message that there may be pre or post dependencies. He's afraid he may invalidate other calibrations by running DC Offsets inside ICW. Is there any way to run this or other calibrations independently of ICW?
Applies to
- Models
- Signa
- Product
- Signa HDxT This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software. This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software.
- Software
- 15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.