GE Healthcare · MRSigna22415522241522
CWA. Will Not Scan with Gradient Errors.
Symptom
Will Not Scan with Gradient Errors.
Error message
2241552 The GIP Reported Several PPBM Faults on the Z Axis of the GPM. Mon Apr 26 19:56:01 2004 Error: 2241552 Host: rmnf Process: NSP File: HPC_PORT_ID:GAP/GIP/GP Line: 2189 The GIP reported several PPBM Faults on the Z Axis of the GPM. Power cycle the main breaker on the GPM Power Supply to recover from this condition. If this fault occurs again, check the GPM & the GPM Power Supply. 2241522 The GIP reported a PPBM Fault on the Y Axis of the GPM. The GPM will recover when the Supply voltage changes to a safe range. Possible causes: Y Axis GPM PPBM, Main Board, Output Shelf, or the GPM Power Supply. Extended Error: This error is generated by the PPBM and would occur under the following conditions a) PPBM was Overtemp b) Input voltage from GPM Power Supply (in Ready) was <80V or >210V c) Average output current >100A. If these are not the problem, then replace the PPBM.
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.