Service Note 43811_1 Sept/09 DST-XL, DST-XLi and DSXi Auto-Contour Frame Overview and Troubleshooting
Symptom
Service Note 43811_1 Sept/09 DST-XL, DST-XLi and DSXi Auto-Contour Frame Overview and Troubleshooting Service Note 43811 _1 Sept/09 DST-XL, DST-XLi and DSXi Auto-Contour Frame Overview and Troubleshooting DST-XL, DST-XLi and DSXi cameras Auto-contour devices are expensive and have a high usage rate. Investigation found the failure was often not the device itself but elsewhere, i.e. cables or the LOPCO-Daughter Board. This document serves as a troubleshooting guide intended to improve service's ability to troubleshoot and determine the root cause. Usage rate will be reduced as aresult.
Applies to
- Product
- SMV DS Camera SMV DS Camera SMV DS Camera
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop