GE Healthcare · Nuclear Medicine
Hawkeye/VH How to continue the TE acquisition after stopping by unknow reason?
Symptom
Hawkeye/VH How to continue the TE acquisition after stopping by unknow reason? Hawkeye/VH: How to continue the TE acquisition after stopping by unknow reason? During doing the TE sequence ( Xray+NM acquisition), after the X-ray acquisition is over, sometimes the acquisition stops when the table arrives the NM acquisition position. How to continue the TE acquisition after stopping by unknow reason
Error message
Error message "Stopped on Unknown"
Applies to
- Product
- VGH VG and VG Hawkey and Varicam
- Component
- *Application Protocol Application - Acquiring and Processing Application Protocol - Acquiring and Processing
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop