GE Healthcare · MRSigna2247388
Receiver Chain Isolation Diags fail Error 2247388 Due to RRF Receiver Board.
Symptom
Receiver Chain Isolation Diags fail Error 2247388. Rx LO Present Error. The LO signal was not detected on the receiver board for the 16 channel system
Error message
2247388 Rx LO Present Error. The LO signal was not detected on the receiver board for the 16 channel system Receiver Chain Isolation Diags fail 2247388 Rx LO Present Error. The LO signal was not detected on the receiver board for the 16 channel system: 13 14 15 16 .
Applies to
- Models
- Signa
- Product
- Signa HDxT This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software. This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software.
- Software
- 15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
- Component
- 2349808 RRF RECEIVER II BOARD See Long Description * A part that does not have a “–2” or “–3” can be replaced with either the same part number or the same number ending with a “–2” or “–3”. If replacing the “–2” or “–3” version, then only the part number with a “–2” or “–3” can be used.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.