GE Healthcare · Nuclear MedicineMillennium
VG gantry Error #75 Drivers Voltage Test H.W.D.T Activated Voltage Disconnected.
Symptom
VG gantry Error #75 Drivers Voltage Test H.W.D.T Activated Voltage Disconnected. VG hawkeye Error #75 happens intermittently. Sometimes switch off the power to the gantry for 10 minutes and then switch it on and all is Ok.
Error message
Error #75 (Error 75) Drivers Voltage Test H.W.D.T Activated Voltage Disconnected GANTRY_ERROR_HWDT_VLTG
Applies to
- Models
- Millennium
- Product
- VGH VG and VG Hawkey and Varicam
- Component
- 5197979 (PCA000492) MCH Board for SPARE PART 5197979 (PCA000492) MCH Board for SPARE PART 5197979 MCH Board is not compatable with VG motion software version 6.0AH Verify VG Gantry Firmware version. VG Gantry Firmware Version must be 6.0P7 . See KOID 153674
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size