GE Healthcare · Nuclear Medicine
Running a PMT calibration and need to adjust the gain resistors need to know location of the PMT for the DST iSeries and…
Running a PMT calibration and need to adjust the gain resistors need to know location of the PMT for the DST iSeries and DSX cameras
Symptom
Running a PMT calibration and need to adjust the gain resistors need to know location of the PMT for the DST iSeries and DSX cameras Running a PMT calibration and need to adjust the gain resistors, need to know location of the PMT for the DST iSeries and DSX cameras.
Applies to
- Product
- SMV DS Camera SMV DS Camera SMV DS Camera
- Component
- *Detector (Imaging Detector) *Detector (Imaging Detector) *Detector (Imaging Detector)
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop