GE Healthcare · MRSigna
Need 12 in cable stub to complete Body Reflected Power Calibration (For For 3.0T systems with LCC300 magnets). 3.0T Sign…
Need 12 in cable stub to complete Body Reflected Power Calibration (For For 3.0T systems with LCC300 magnets). 3.0T Signa HDxT 15.0.
Symptom
3T Rf amp UPM cal procedure section 4.3 body reflected power calibration calls for 12 in. cable stub, its not in the RF power measurement kit.
Applies to
- Models
- Signa
- Product
- 3.0T Signa HDxT For 3.0T Signa HDxT systems with 15.0 software only. For 3.0T Signa HDxT systems with 15.0 software only.
- Software
- 15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
- Component
- 12 inch cable stub .This cable part number is 5169478, but cannot be ordered at this time( Aug 2009) 12 inch cable stub .This cable part number is 5169478, but cannot be ordered at this time( Aug 2009).
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.