Installed Maxxus 46-323774P2, Maxxus scan motion would not PMI after installing 46-323774P2 CABLE ASSEMBLY, SCAN TACHO,…
Installed Maxxus 46-323774P2, Maxxus scan motion would not PMI after installing 46-323774P2 CABLE ASSEMBLY, SCAN TACHO, ENCODER
Symptom
Installed Maxxus 46-323774P2, Maxxus scan motion would not PMI after installing 46-323774P2 CABLE ASSEMBLY, SCAN TACHO, ENCODER The scan would move all the way to the end stop during PMI, and continue on triggering the torque limiter. This could be in either direction (it seemed random), the limit switches were ignored. Moving the scan with the JOG box caused the scan to move and continue moving even after the jog button was released - until the endstop was hit, or the axis on the JOG box was changed (disabling the scan axis)
Applies to
- Product
- Maxxus Maxxus product Maxxus product
- Component
- 46-323774P3 Maxxus SCAN POT & ENCODER CABLE 46-323774P3 Maxxus SCAN POT & ENCODER CABLE *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop