Unable to Partition Hard Drive in 9.1 Load From Cold.
Symptom
Unable to Partition Hard Drive in 9.1 Load From Cold During the 9.1 LFC procedure, FE was unable to partition the hard drive. He sees the error message "Unable to access dksc0d1" when trying to partition the hard drive using the boot/update disk at step 2-5 on page 11 of Rev. 1 of the HOST SOFTWARE INSTALL RELEASE 9.1 procedure on LX Service Methods. The error message appears after fx: ctlr# = (0) fx: drive# = (1) During the 9.1 LFC procedure, FE was unable to partition the hard drive. He sees the error message "Unable to access dksc0d1" when trying to partition the hard drive using the boot/update disk at step 2-5 on page 11 of Rev. 1 of the HOST SOFTWARE INSTALL RELEASE 9.1 procedure on LX Service Methods. The error message appears after fx: ctlr# = (0) <Enter> fx: drive# = (1) <Enter>
Error message
Unable to access dksc0d1 Error message during LFC on monitor
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.