GE Healthcare · X-ray R&FDefinium
The Positioner vertical lift intermittently does not hold its position.
Symptom
The Positioner vertical lift intermittently does not hold its position. See Long Description The D5K positioner vertical lift does not hold position from lift motor drive stop to brake engagement. It will intermittently/typically drop about an centimeter, post vertical travel request (at the travel motion stopping point) both in up and down motion. The vertical brake does engage properly, but does have a slight delay (fraction of a second) in actuation, which is enough time to allow noticeable drift.
Applies to
- Models
- Definium
- Product
- Definium 5000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.