GE Healthcare · Nuclear MedicineMillennium
Millennium MPR/MPS gantry fails to initialize roll motion, rotates to end limit and fails with error 15.
Symptom
Millennium MPR/MPS gantry fails to initialize roll motion, rotates to end limit and fails with error 15. Millennium MPR/MPS gantry fails to initialize roll motion, rotates to end limit and fails with error 15
Error message
Calibration failed on Roll axis - error #15 Error log entry when it fails: 2008/07/30 23:54:56 EST genieacq:gip_ph;83:gip_recv.c[$Revision: 1.63.2.16 $] handleCntlMsg() line 1301 error 0x07100005 level 2 "Calibration error reported on the Roll axis." 2008/07/30 23:54:56 EST genieacq:tgc_ph;102:moveio.c[$Revision: 1.11.2.6 $] mio_gip_r_cal() line 1624 error 0x14300019 level 3 "GIP_R_CALIBRATE: Error 15 for ROLL axis." 2008/07/30 23:54:56 EST genieacq:tgc_ph;102:calib.c[$Revision: 1.37.2.3 $] cal_gip_cal_reply_proc() line 446 error 0x14300003 level 2 "ROLL calibration failure."
Applies to
- Models
- Millennium
- Product
- MPR/MPS Millennium MPR Millennium MPS
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size