GE Healthcare · X-ray R&FDefinium
Definium 5000 Unable to reassemble Embedded PC after replacing Compact Flash The Embedded PC initially would n…
Definium 5000 Unable to reassemble Embedded PC after replacing Compact Flash
Symptom
Definium 5000 Unable to reassemble Embedded PC after replacing Compact Flash The Embedded PC initially would not boot, FE was in the process of replacing the Compact Flash but after disassembling the PC, FE did not know where all the connectors went. There is no internal layout of the PC, no photos for reference.
Applies to
- Models
- Definium
- Product
- Definium 5000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.