GE Healthcare · X-ray R&FDefinium
Def8000 Wallstand only system, the "table" e-stop function is not satisfied since the E-stop loopback connector was not…
Def8000 Wallstand only system, the "table" e-stop function is not satisfied since the E-stop loopback connector was not installed.
Symptom
Def8000 Definium 8000 Wall Stand Only Systems have no table, and they need to somehow bypass the eStop circuitry built into the Definium table.
Error message
Def8000 Without the bypass jumper in place, the system can not be used because the eStop function is not satisfied. A warning message about the eStop will be presented to the Operator.
Applies to
- Models
- Definium
- Product
- Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.