GE Healthcare · Nuclear MedicineMillennium
MG Gantry starts to shake or vibrate (sometimes makes noise) and stops with a following error during High speed cardiac…
MG Gantry starts to shake or vibrate (sometimes makes noise) and stops with a following error during High speed cardiac motion
Symptom
MG Gantry starts to shake or vibrate (sometimes makes noise) and stops with a following error during High speed cardiac motion System will move fine with the hand controller in slow motion and when the detectors are in opposed mode. Problem only occurs when detectors are on one side or when at highest load and driving roll at fast speed.
Error message
Error #9 (Error 9) Following error Motion ended because of a following error. Error #9 (Error 9) Following error Process gip_mx: Motion ended because of a following error
Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size