GE Healthcare · MRSigna
Unable to Print Due to No Communication Between the DASM and Camera.
Symptom
Showdasm command fails with ffffff. After running uninstall and install dasm from ~sdc/install, a message comes up stating to setenv FILM_DASM_DEV /dev/dasm1 appropriately.
Error message
Could not initialize_scsi status = ffffffff See Long Description Error occurs when running showdasm command. See typical session below from a 9.1 M4 system and the resulting error in red. lx-mr# su root [Enter] [enter root password] lx-mr# showdasm [Enter] set environment variable FILM_DASM_DEV appropriately lx-mr# setenv FILM_DASM_DEV /dev/dasm1 [Enter] lx-mr# ./showdasm [Enter] Could not initialize_scsi status = ffffffff
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.