software issue when doing system restore in SUIF->Utilities->System->restore
Symptom
software issue when doing system restore in SUIF->Utilities->System->restore On Feitian v15 used in Definium serial products, there’s an existing software issue when doing system restore in SUIF->Utilities->System->restore, which might result in no end when operator waiting for the procedure to be complete. In Definium 6000 serial products, which install feitian V15 software by the FMI, when perform system data restore, the tip of information will be no any change when doing “OS Cofiguration” item after it begins to restore, even though the procedure has already finishe
Applies to
- Models
- Definium
- Product
- Definium 6000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.
- Definium 8000 OTS Collimator has no power due to a tripped breaker (CB8) ont he Tube Suspension Logic (TSL) Board.
- Definium 8000 The Siemens Collimator has not power due to a tripped breaker (CB9) on the Tube Suspension Logic (TSL) Board.