GE Healthcare · Nuclear Medicine
VG gantry reboot, GDU display error message #83 Drivers voltage test SSR control bit mismatch
Symptom
VG gantry reboot, GDU display error message #83 Drivers voltage test SSR control bit mismatch
Error message
Error #83 (Error 83) DRIVERS VOLTAGE TEST: SSR control bit mismatch
Applies to
- Product
- VGH VG and VG Hawkey and Varicam
- Component
- *Gantry Gantry Gantry 5176677 Infinia Driver 200V/15A for Table Up/Down, Radial 1 & 2 (and Lateral when Radials are disabled) 5176677 Infinia Driver 200V/15A for Table Up/Down, Radial 1 & 2 (and Lateral when Radials are disabled) High voltage motor driver 200V/15Amp, controls the following axes: Radial in/out Head #1, (or Lateral motion in L Mode) Radial in/out Head #2 Table Up/Down
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop