Skip to main content
ProcedureGantryReplacementReplace

Replace a gantry laser-positioning projector lamp

Replace the lamp in one of the Activion16's rotation-section laser positioning projectors. The gantry carries four of these projectors — median-line, slant, left-side, and right-side — each mounted independently on the rotation section, so you can service one without disturbing the other three.

Applies to
Activion16 (TSX-031A). No model- or revision-specific restriction is stated in source; applies to any of the four rotation-section-mounted laser positioning projectors (median-line, slant, left-side, right-side).
Personnel
"Not specified in source manual for this section"
Steps
2 steps
Source
2D201-112EN*D §1.4.1 (p.57) — Replacing the projector lamp

Safety

WARNING

Hazard: System laser beam device (rotation-section positioning projectors)

Consequence: Eye injury

Avoidance: Do not look directly into the laser beam

Full step-by-step for Replace a gantry laser-positioning projector lamp

All 2 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

7-day free trial · no credit card required

Related Gantry guides

View all Activion16 (TSX-031A) guides

Related error codes

Source: 2D201-112EN*D §1.4.1 (p.57) — Replacing the projector lamp. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.

“That they may see, and know, and consider, and understand together, that the hand of the LORD hath done this.”Isaiah 41:20