Skip to main content
ProcedureGantryReplacementReplace

Remove and refit the gantry dome cover

Remove the dome cover to reach the slip ring and brush section behind it — for example to troubleshoot slip-ring noise/discharge, clean the ring, or replace worn brushes (see Related) — then refit it. The dome cover sits behind the rear covers in the gantry's cover stack, so removing the rear covers (§1.3.4) is a prerequisite step here, not something this task repeats.

Applies to
Activion16 (TSX-031A). No model- or revision-specific restriction is stated in source for this task.
Personnel
1 technician · Field service engineer (CT gantry, basic mechanical/electrical service)
Steps
5 steps
Source
2D201-112EN*D §1.3.5 (p.54) — Removing/Mounting the dome cover

Tools & parts

ItemPart numberQty
Dome cover—1
Mounting screws, M4—4
Cable clamp—1

Safety

DANGER

Hazard: Slip ring and brush section behind the dome cover carries high voltage while the distribution-board breakers are energized

Consequence: Electric shock

Avoidance: Turn OFF all breakers on the distribution board before removing the dome cover (Step 1) — never open this cover with the breakers energized

Full step-by-step for Remove and refit the gantry dome cover

All 5 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

7-day free trial · no credit card required

Related Gantry guides

View all Activion16 (TSX-031A) guides

Related error codes

Source: 2D201-112EN*D §1.3.5 (p.54) — Removing/Mounting the dome cover. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.

“That they may see, and know, and consider, and understand together, that the hand of the LORD hath done this.”Isaiah 41:20