Skip to main content
ProcedureGantryFunctional ChecksMeasure

Check the safety circuit on the KGTSM PWB

Verify that the KGTSM's stationary-section safety circuit — the circuit that cuts gantry-tilt, couch-vertical, and couch-horizontal power on a fault — actually works, that its internal timers time out correctly for each of the three motions, and that the couch-top slide runout detector locks the couch top and flags LED75 when the top is pushed past its allowed free travel. Do this as a functional

Applies to
Activion16 (TSX-031A) gantry with KGTSM servo/motion control PWB. Covers the stationary-section safety circuit backing gantry tilt, couch vertical movement, and couch horizontal (slide) movement, plus the couch-top slide runout detector. Requires a PC running Hyper Terminal and a service cable connected to KGTSM connector CN404.
Steps
53 steps
Source
2D201-112EN*D §3.9.7–3.9.7.3 (pp.329-335) — Check of safety circuit on the KGTSM PWB

Safety

CAUTION

Hazard: Disconnecting CN451 of the KGTSM PWB (source's own verbatim caution)

Consequence: Disconnecting CN451 turns OFF the power of the tilt motor, rotation servo system, couch, etc.; if the safety circuit is defective or if your operation was incorrect, the tilt, rotation motor, or couch may move

Avoidance: Disconnect CN451 of the KGTSM PWB before running the safety-circuit checks below, and keep it disconnected throughout the tilt / vertical-movement / horizontal-movement sub-checks

CAUTION

Hazard: Starting the safety-circuit checks without first confirming the area and the CN451 disconnection (source's own pre-check checklist, not itself labeled CAUTION but stating an electric-shock and crush hazard)

Consequence: a worker touching parts that may cause an electric shock, or a worker or object present at a location where they may be crushed, once CP1 power and commanded tilt/vertical/horizontal motion resume

Avoidance: Before starting inspection work, confirm no workers are touching parts that may cause an electric shock, confirm no workers (or objects) are present at a location where they may be crushed, and confirm CN451 on the KGTSM PWB is disconnected

Full step-by-step for Check the safety circuit on the KGTSM PWB

All 53 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

7-day free trial · no credit card required

Related Gantry guides

View all Activion16 (TSX-031A) guides

Related error codes

Source: 2D201-112EN*D §3.9.7–3.9.7.3 (pp.329-335) — Check of safety circuit on the KGTSM PWB. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.

“That they may see, and know, and consider, and understand together, that the hand of the LORD hath done this.”Isaiah 41:20