ProcedureElectronicsReplacement

Replace the keypad & display module

Swap the DryStar 5300's front-panel Keypad & Display module (spare part **CM+343336.X**) in about 15 minutes, using only a crosshead screwdriver, once the Front and Right side covers are off (p.293). This section of the manual does not use a module number for the part — the printer's error catalogue and module lookup table elsewhere in the manual identify this same module as **MOD09** (see Related).

Applies to

DryStar 5300 (Type 5365/100)

Personnel

1 technician · Basic — open the already-documented Front and Right side covers, unplug two connectors (A)/(B), remove two screws (C)/(D), and swap the module; no calibration, software configuration, or torque value is stated in this source section.

Steps

0 steps

Source

DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5/19-20, Section 2.1 Keypad & Display module, Edition 1 Rev.7 (2005-08-05), p.293-294

Tools & parts

Item	Part number	Qty
Keypad & Display module	CM+343336.X	1
Crosshead screwdriver	n/a in source	1

Full step-by-step for Replace the keypad & display module

All 0 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Electronics guides

Replace the compact flash card0 steps Replace the main board cooling fan18 steps Replace the main board (VILIS - Themis)20 steps Replace the OSB switch board12 steps Replace the power supply16 steps Replace the safety switch17 steps

View all DryStar 5300 guides

Source: DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5/19-20, Section 2.1 Keypad & Display module, Edition 1 Rev.7 (2005-08-05), p.293-294. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.