ProcedureElectronicsReplacement

Replace the compact flash card

Swap the DryStar 5300's internal Compact Flash card — the card the printer's software is loaded onto (derived: source only points to a separate SW-installation procedure, it does not describe what the card stores) — in about 15 minutes with nothing more than a crosshead screwdriver.

Applies to

DryStar 5300 (Type 5365/100)

Personnel

1 technician · Service-level technician — opens the Top, Front, and Right side covers, removes the EMI shield screws, and swaps the internal Compact Flash card using a crosshead screwdriver. Per source, installing software onto the new card is a separate topic covered in Chapter 3.2, Tools, not in this section (derived — source does not assign a formal skill-level label to this section).

Steps

0 steps

Source

DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5, item 2.2, Edition 1, Revision 7 (2005-08-05), p.295-297 (Type 5365/100)

Tools & parts

Item	Part number	Qty
Compact Flash card, 128 MB	CM+343356.X	1 (derived — source lists it as a single required-spare-part line item, no explicit count)
Crosshead screwdriver	n/a in source	1 (derived — source lists it as a single required-tool line item, no explicit count)

Full step-by-step for Replace the compact flash card

All 0 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Electronics guides

Replace the keypad & display module0 steps Replace the main board cooling fan18 steps Replace the main board (VILIS - Themis)20 steps Replace the OSB switch board12 steps Replace the power supply16 steps Replace the safety switch17 steps

View all DryStar 5300 guides

Source: DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5, item 2.2, Edition 1, Revision 7 (2005-08-05), p.295-297 (Type 5365/100). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.