GE Healthcare · Nuclear MedicineInfinia

Need part number for Infinia or VG Collimator ID board

Symptom

Need part number for Infinia or VG Collimator ID board Collimator ID part number of PCA000111 is invalid, see resolution. Need part number for Infinia or VG Collimator ID board The collimator ID part number of PCA000111 is invalid, see resolution.

Applies to

Models
Infinia
Product
VGH VG and VG Hawkey and Varicam Infinia I Infinia I Acquisition System Infinia HE4 Infinia II Hawkeye 4 & Infinia II GP (Infinia running Windows XP software) Infinia II Infinia II Acquisition System
Component
*Collimator/ Collimator cart Collimator/ Collimator cart 5338523 Two Collimator ID Boards (Kit) 2199382 Collimator ID Board Part replaced by 5338523 . This part is for the new Collimator ID design. Please refer to SN 43837 for instructions If your system is equiped with the old design (2199382) then you will need to order 5342601 - First Time Collimator ID UPgrade Kit ( FMI 40822 ). Note: The screws holding the ID pcb's on the collimator may have been secured with hard or permanent loctite making it very hard to remove the screws The screws that holding the Collimator ID board is defined to be secured by Loctite 222 (that can be untightened later). To open the screws should use the right tool - Phillips screwdriver PH #2.
Area
Nuclear Medicine

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare Nuclear Medicine issues