Unable to Scan With Multi Coil Bias Faults.

Symptom

Error message

2252301 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCDx Channel x of y, counting from 1 Value x mA Limit y mA See Long Description for Extended Error 2252301 MRI_GB_OW0 NSP SCP:DCB 816 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCD1 (or MCD2) Channel 1 of 16, counting from 1 Value: 2 mA Limit: 298 mA Mask of failed channels: 0x1 Ch 1-8 : Legacy MC Conn Ch 17-24 : Conn A Ch 25-32 : Conn B-> Extended Error: This fault was detected by the Driver Module. An open circuit fault occurs when the actual value is less than the pre-defined limit. Check system cables, connectors, coils and configurations. Re-seat all coil connectors. The mask of all failed channels indicates additional channels with the same fault - convert the hex number to a bitmap to decipher the mask, with channel 1 indicated by the least significant bit and channel 16 indicated by the most significant bit. For example, a mask of 0x3c converts to 0011 1100, meaning channels 3, 4, 5, and 6 all experienced the same failure. The key at the bottom of the error message shows the MC driver bias channels provided by the Driver Module used with each mult

Applies to

Models

Excite

Product

Excite HD For 12.0 1.5T Systems only.

Software

12.0 Excite HD and 3T Excite HD products only

Area

MR

Related GE Healthcare MR issues

• CWA How to Change Date or Time on LX, Excite, HD, HDe, HDx, HDxT, HFO, Excite HFO, Ovation1-4, Profile1-5, Discovery MR450 MR750 and Optima 450w Systems.
• CWA No Power to the Table and Magnet Display, Table Will Not Move And No Lights On the Magnet.
• CWA How to Change Exam Number from Remote Tools.
• Known Software issue with 15M4B coding error.
• Unable to Send Images to the PACS Due to PACS is down.
• U41 of the Slave RF Ctrl Assy, part of the PSU in the SRFD2 RF Amplifier Failed.