GE Healthcare · X-ray R&FPrecision
P500D Turning power on at the RCIM or the Corona Power On Switch, all LEDs on the Corona are flashing and syst…
Precision 500D RCIM or the Corona Power On Switch, all LEDs on the Corona are flashing and system will not power up correctly.
Symptom
P500D Turning power on at the RCIM or the Corona Power On Switch, all LEDs on the Corona are flashing and system will not power up correctly. P500D Turning power on at the RCIM or the Corona Power On Switch, all LEDs on the Corona are flashing and
Applies to
- Models
- Precision
- Product
- Precision 500D
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.