P500 The M3 software release does not properly sync the Protocols with the installed Options.
Precision 500D Calibration and Configuration Protocol details not consistent with options installed, Rad, DSA, Pulsed Fluoro
Symptom
P500 The M3 software release does not properly sync the Protocols with the installed Options. See long description: This issue occurs under the following conditions: 1. Perform a complete software load from cold. (The config defaults after this are No OTS, No DSA, No Pulsed Fluoro.) 2. Restore protocol database from Software CD. (Purchased Options have not been enabled in Service Config Screens.) After protocol database is loaded, there are Rad, DSA, Pulsed Fluoro protocols and protocol steps present for Customer Selection."
Applies to
- Models
- Precision
- Product
- Precision 500D
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.