GE Healthcare · X-ray R&FPrecision
No power to the cooling fans on the X-Ray Tubes.
Precision 500D 80-0902 Error no power to the cooling fans on the X-Ray Tubes.
Symptom
No power to the cooling fans on the X-Ray Tubes. 115 VAC is missing on the Rotor Control Board. Check by looking at DS6 on the Rotor Board; it's located in the upper right side of the board.
Error message
Error 80-0902 Tube Fan Supply Error (no 120 VAC present). There is no power to the cooling fans on X-Ray Tubes.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.