GE Healthcare · X-ray R&FPrecision2000133600062
P500D Errors 200013 and 3600062.
Precision 500D Errors 200013 and 3600062 with exposure on overhead tube
Symptom
P500D Errors 200013 and 3600062. Unable to make an exposure with the overhead tube but the undertable tube works fine.
Error message
Error 200013 (Time out waiting for an event or actor to respond) with exposure on overhead tube. Error 3600062 (Generator KV is too low or mA/mAs is too high) with exposure on overhead tube.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Component
- JEDI Generator This generator is used on Proteus and Precision 500D systems.
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.