GE Healthcare · X-ray R&FPrecision
P500D During AV03 IRIS LUT Calibration, procedure is to set 2 cm Aluminum block in the field and increase fluo…
Precision 500D Unable to set 3000 Brightnesss value during AV03 Iris LUT calibration
Symptom
P500D During AV03 IRIS LUT Calibration, procedure is to set 2 cm Aluminum block in the field and increase fluoro mA until ABD brightness reading reaches 3000. One M4 site reported problems achieving this value. Brightness value would not increase beyond 2450 despite increase in image intensifier light output and increase in fluoro mA setting.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.