GE Healthcare · X-ray R&FPrecision
P500D Digital System (Saturn Computer) Networking configuration is normally done via the I.U.I.
Precision 500D access to the Digital Saturn computer networking parameters.
Symptom
P500D Digital System (Saturn Computer) Networking configuration is normally done via the I.U.I. Operator console. This provides an HTML browser interface which communicates with the Windows 95 operating system on the Digital system. In some conditions, it is necessary to access the Digital computer networking setup screen directly. Follow the procedure provided in this solution.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Component
- P500D Saturn Digital Computer
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.